How To Calibrate a Microtouch Monitor

Home › Forums › Knowledge Base › Hardware › Legacy Hardware › How To Calibrate a Microtouch Monitor

  • This topic has 0 replies, 1 voice, and was last updated 19 years ago by Rob.
Viewing 1 post (of 1 total)
  • Author
    Posts
  • April 14, 2006 at 12:20 am #1451
    Rob
    Member

    How To Calibrate a Microtouch Monitor

    Last edited: December 15, 2003 08:14 AM

    To calibrate a Microtouch monitor:

    1.  From your “c” prompt (c:>) type:
    mtcalib

    This will open the Calibration Utility. Follow the instructions to calibrate the screen within the utility. After you calibrate your MicroTouch, power down the CPU and monitor.  When you power up the drivers and touch board will be reset.

  • Author
    Posts
Viewing 1 post (of 1 total)
  • You must be logged in to reply to this topic.