Swecoin Printer Model 111ATD
Last edited: December 15, 2003 08:18 AM

Power switch is a rocker switch mounted below and to the left of the printer.  Red button at left rear is paper feed.  If powered on with button depressed will run self test.  Self test ends with a cut and eject when red button is released.  IO is parallel.
Switches

All switches off(default)
Paper

Thermal paper.  Loads shiny side up.  Head release lever on the left pulls toward the front and down to load paper.  Paper loads under small metal bar, then under print head.  Put lever back in the up position when done.
Escape Codes

  Black Print 27, 102,  1  Initialize to eject while printing
  Red Print  27,  12, 10  Clear paper chute
  Normal Size 27,  14, 14  Quad size print
  Paper Cut  30,  0,  0  Cut and eject
Styling

Template should look as follows:
              {SET Black Print}
              {SET Red Print}
              {SET Normal Characters}

            …. (body of template) ….

      …. (app. 10 blank lines for footer) …

              {Paper Cut}

The Form Feed command does not work with the Swecoin printer.  You must explicitly put in blank lines to advance the paper.  Also note that it is a 36 column printer.  There is no Large Print and the template should not try to print in the last 4 columns.