Swecoin Printer Model 111ATD

Home Forums Knowledge Base Hardware Legacy Hardware Swecoin Printer Model 111ATD

  • This topic has 0 replies, 1 voice, and was last updated 19 years ago by Rob.
Viewing 1 post (of 1 total)
  • Author
    Posts
  • #1480
    Rob
    Member

    Swecoin Printer Model 111ATD
    Last edited: December 15, 2003 08:18 AM

    Power switch is a rocker switch mounted below and to the left of the printer.  Red button at left rear is paper feed.  If powered on with button depressed will run self test.  Self test ends with a cut and eject when red button is released.  IO is parallel.
    Switches

    All switches off(default)
    Paper

    Thermal paper.  Loads shiny side up.  Head release lever on the left pulls toward the front and down to load paper.  Paper loads under small metal bar, then under print head.  Put lever back in the up position when done.
    Escape Codes

      Black Print 27, 102,  1  Initialize to eject while printing
      Red Print  27,  12, 10  Clear paper chute
      Normal Size 27,  14, 14  Quad size print
      Paper Cut  30,  0,  0  Cut and eject
    Styling

    Template should look as follows:
                  {SET Black Print}
                  {SET Red Print}
                  {SET Normal Characters}

                …. (body of template) ….

          …. (app. 10 blank lines for footer) …

                  {Paper Cut}

    The Form Feed command does not work with the Swecoin printer.  You must explicitly put in blank lines to advance the paper.  Also note that it is a 36 column printer.  There is no Large Print and the template should not try to print in the last 4 columns.

Viewing 1 post (of 1 total)
  • You must be logged in to reply to this topic.