Immage CPU
Last edited: December 15, 2003 08:09 AM
Cabling

UDM COM port to UDM COM port(used with INTERLNK)
   

---

   

---

  DSR    3  —  5  DTR
  TXD    4  —  6  RXD
  DTR    5  —  3  DSR
  RXD    6  —  4  TXD

  Note:  Do NOT connect pins 1 or 8 as they contain voltages up to 30V.
I/O Device

AMC Mag Stripe Reader

                RJ45            HR0025        DB9
                Immage                          MSR

Black            3    RXD  —  3  —  2
Green          5    TXD    —  2  —  3
Orange        2    GRD    —  7  —  5
Yellow          6    DSR    —  6  —  8
                                      5
                                      8

Ardac Bill Acceptor

                RJ45            DB25
                Immage        Ardac

Black            3                  3
Green          5                  2
Orange        2                  7
Lantastic

UDM requires that AI-NDIS protocal manager be installed along with Lantastic as network card is not directly supported by Lantastic.

[color=red:30qn75pb][u:30qn75pb][b:30qn75pb]Download network files[/b:30qn75pb][/u:30qn75pb][/color:30qn75pb][/url:30qn75pb]
Config.Sys

Add these commands:

DEVICE=C:LANTASTIPROTMAN.DOS /I:C:LANTASTI

DEVICE=C:LANTASTISMC9000.DOS

Autoexec.Bat

Add this command:

AI-NDIS BIND_TO=SMC9000_NIF
Files Needed on Hard Drive

PROTMAN.EXE
PROTMAN.DOS
PROTOCOL.INI
SMC9000.DOS
REDIR
AI-NDIS
AILANBIO
NETBIND.COM
NET.EXE
MEMSET Command

The UDM video mode is programmable.  It is therefore possible for it to lose its video setting.  The result of this occurence is that the display in Touchnet will have strange flashing characters on some screens instead of the correct graphics character. The fix is to run:
        MEMSET CLEAR
This utility resides in the UTIL directory.